Aerated concrete production process: according to the raw materials category, quality, technical characteristics of major equipment and the like, take a different process for production. However, under normal circumstances, aerated concrete is fly ash or silica sand and ground into a slurry with water, add powdered lime brick factory Huangpi aerated, the amount of cement, plaster and foam filling blocks, injection mold after stirring box, after the static oxygen foam cured, cut into various specification block or plate, keep a car from the steam into the autoclave under high temperature saturated steam curing that the formation of a porous lightweight aerated concrete products. First filling block after raising and cutting casting mold conveyor chains push early raise gas chamber made the initial setting, the room temperature is 48 ~ 68 ℃ Huangpi aerated block custom, early care time is 1.5-2 hours (depending on the geographic advantageous Conditions can be removed from this process), after initial support by the vacuum spreader mold box and green body with crane to put away pre-cutting table kettle floor. Remove mold box. Cutting machine that is blank transected, slitting, milling surface Baotou, mask hanging back operation mode the car manual cleaning and oiling Huangpi aerated block wholesale, then hang the mold car group mode for the next casting, Good body after cutting the floor along with the kettle to the pot with a crane hanging car stacked two layers, the interlayer has four support, a number of tank car series as a group. Huangpi aerated brick factory, riverbank aerated block, cement pavilion by pavilion Hongshan District of Wuhan cement operation. Hongshan District of Wuhan pavilion cement business unit (www.whltsn.com) (www.hbltsn.com) strong, credible, in Wuhan of cement and related products industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead gazebo cement into the brilliant and you work for a better future!