Aerated autoclaved and finished green body in the kettle before the stop line after the group finished, open to the autoclave autoclave door Autoclave aerated block, pulled out the first hoist kettle kettle car finished Wuhan aerated block manufacturers, then prepare autoclaved the kettle vehicle hoist pull into the autoclave conservation. Kettle car manufactures bridge cranes hanging with the finished products, and then use the fork lift truck transport to finished yard Wuhan aerated block factory, empty kettle cars and kettle hanging back to the carriage bottom line, clean up after use hoist frame at the back yard for the next cycle. Gouges in the wall cladding tube, you should use special tools, can not arbitrarily cut with an ax or a spatula chisel, pipe wall surface should be below 4 ~ 5mm, and pipe and the wall card prison, not a loose rebound phenomenon, then watering moist, caulking strength equivalent to the use of masonry mortar, and reinforcing the walls and laying 10mm × 10mm steel wire along the pipe laying direction, it should be across the slot width on each side of not less than 50mm, stretch tight clinch. Wuhan aerated block device | pavilion cement (certified) | aerated blocks provided by the Hongshan District of Wuhan pavilion cement operation. Hongshan District of Wuhan pavilion cement business unit (www.whltsn.com) (www.hbltsn.com) was Wuhan, cement and products leader, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, the maximum Limits to meet customer needs. Cement leader in the pavilion with the staff warmly welcome all inquiries negotiations to create a better future for cement pergola.